Search
Post Requirements
Post Requirements
Product information
The LA100 series quick connectors are designed to provide a quick and airtight connection to straight tubes, drilled holes, etc. The LA100 quick connectors are attached to the inner wall of the test fittings by means of a sealing ring on the front of the connector, and must be used at pressures below 1 bar.
It is important to ensure that the sealing surfaces of the connector and the test piece are dry during use, and that if the sealing surfaces are lubricated with water or other lubricants, they can only be used at pressures of less than 1 bar.
Advantages of the product:
1. Can seal straight pipes or drilled holes with a wide range of tolerances;
2. Seals are self-adaptive;
3. No damage to test fittings.
Range of applications:
Realise rapid sealing test of pressure and vacuum on straight pipes, drilled parts.
Technical parameters:
Working pressure] 3 bar (Max)
Dewatering rate] 10-4 mbar-l/s (10-5 Pa-m3/s)
Working Temperature】+5℃ ～ +80℃
Sealing medium]: Oil-free, dry air or other non-corrosive gases.
Driving mode] Handle drive
Body material]: Aluminium alloy (surface treatment: anodic oxidation)
Sealing material]: Nitrile rubber (NBR), other materials can be selected according to demand.
Test procedure]: Insert the LA100 quick connector into the test piece as shown below; rotate the handle of the quick connector by 90° to achieve connection sealing, and then apply test pressure; at the end of the test, rotate the quick connector back to 90° and remove it.
